Attention ! Due to COVID-19 situation, please expect delay in shipping and Delivery time could be longer. Prepaid order will be preferred 1st than COD order. We are available on Email only for all your queries. Thanks for your understanding & support.
  • 1 Channel 5V Relay Module without Optocoupler

This is 1 Channel 5V Relay Board Module For Arduino PIC AVR DSP ARM. A wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on can control it.

Each one needs 15mA - 20mA driver current and Equipped with high current relay: DC 5V / 10A, AC 250V / 10A

Standard interface that can be compatible with microcontroller.


Specification and Features :-

  • 1 channel relay board
  • Operating Voltage 5V
  • Max Current : 20mA
  • Relay Contact Current Capacity at AC250V: 10A
  • Relay Contact Current Capacity at DC5V: 10A
  • One normally closed contact and one normally open contact
  • Triode drive, increasing relay coil
  • High impedance controller pin
  • Pull-down circuit for avoidance of malfunction
  • Power supply indicator lamp
  • Control indicator lamp
  • Indicator for Relay output status
  • Can Be controlled various appliances & other Equipment With Large current.
  • Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
  • The module is compliant with international safety standards, control and load areas isolation trenches;

Write a review
Please login or register to review

* Product Images are shown for illustrative purposes only and may differ from actual product.

1 Channel 5V Relay Module without Optocoupler

  • Product Code: EC-4504
  • Availability: 12
  • Rs.68.00