This module consists of a 5mm RGB LED and three 150Ω limiting resistors to prevent burnout. Adjusting the PWM signal on each color pin will result in different colors.

This is a DIP 3 Color LED Module. Through the PWM adjusting, three primary colors can be mixed to obtain different colors.

Connect the red pin (R) on the KY-016 to pin 11 on the Arduino. Blue (B) to pin 10, green (G) to pin 9 and ground (-) to GND. Notice that you do not need to use limiting resistors since they are already included on the board.

Features and Specifications:-

• The use of plug-in full-color LED.
• RGB trichromatic limiting resistor to prevent burnout.
• With a variety of single-chip interface.
• Through the PWM adjusting, three primary colors can be mixed to obtain different colors
• The working voltage: 5V

Package Includes:-

1 x RGB 3 Color LED Module