Winter Sale!! Flat 10% Off on Prepaid Orders, Apply Coupon  WINTER10  in your Cart to get Instant 10% Discount. Last Few Hours!

Many control boards are not rated sufficiently to take the large DC currents generated by 3d Printer hotbeds and some of the higher power Hot end heaters. This is particularly true for 12V systems.

You can largely eliminate the problems of this nature by fitting a MOS25 FET heating controller to your heat bed circuit and ideally your hot-end circuit too. The MOS25 is rated for High current up to 25A, on no account should this be exceeded. 25A is 300 Watts at 12V. You must also ensure that when wiring to the board your wire is suitably rated for the expected current and terminated.


Features:

MKS MOS25 supports high power heated bed, supports a maximum current 25A.


Package included:

1 x 3D printer heating controller MKS MOS25 V1.0 for heat bed extruder MOS



Brand/Manufacturer Generic
Country Of Origin China
Packer / Importer Address Constflick Technologies Limited, Building No 13 and 14, 3rd Floor, 2nd Main, Siddaiah Road, Bangalore, Karnataka - 560027 India.
MRP Rs. 588.82 (Inclusive of all Taxes)
Write a review
Please login or register to review

* Product Images are shown for illustrative purposes only and may differ from actual product.

MKS MOS25 V1.0 3D printer Heating Controller for Heat Bed Extruder MOS

  • Product Code: EC-7886
  • Availability: 4
  • Rs.491.00
  • (Excluding 18% GST)

OR

For all Bulk & B2B Product Enquiries Kindly share your requirement at care@electronicscomp.com