The WIZnet W6100-Q is a Hardwired TCP/IP embedded Ethernet Controller that enables easier Internet Connection for embedded Systems using SPI (Serial Peripheral Interface) and Parallel Bus that incorporates IPv6 and is pin compatible with W5100S

WIZnet W6100-Q suits users in need of stable Internet Connectivity Best, using a single chip to implement TCP/IP Stack, 10/100 Ethernet MAC, and PHY. The implemented Hardwired TCP/IP stack supports TCP, UDP, IPv4, ICMP, ARP, IGMP, and PPPoE which has been proven through various Applications over many years. W6100 uses a 16 Kbytes Internal Buffer as its Data Communication Memory.

By using W6100, users can implement the Ethernet Application they need by using a simple socket Program instead of handling a complex Ethernet Controller. It is possible to use 8 independent hardware sockets simultaneously.

WIZnet W6100-Q users can implement High-Speed Network Communication. In order to reduce the power consumption of the system, W6100 provides a Power Down mode and can be enabled by Wake On Lan.

NOTE: The new W6100 and W5100S are not fully pin-to-pin compatible with the W5100, but the software compatibility is kept, hence the software for the W5100 can be used with the W6100/W5100S without any modification.

Note: For more technical details go through Datasheet in the attachment section

Features:

1. Supports hardwired TCP/IP protocols: TCP, UDP, IPv6, IPv4, ICMPv6, ICMPv4, IGMP, MLDv1, ARP, PPPoE
2. Supports IPv4/IPv6 dual stack
3. Supports 8 independent SOCKETs simultaneously with 32KB memory
4. Supports SOCKET-less commands: ARP, ICMPv6 (ARP, DAD, NA, RS) command for IPv6 auto-configuration & network monitoring (PING, PING6)
5. Supports Ethernet PHY power down mode & system clock switching for power save
6. Supports wake on LAN over UDP
7. Supports serial & parallel HOST interface: High speed SPI (MODE 0/3), system BUS with 2 address signal & 8bit data
8. Internal 32Kbytes memory for TX/ RX Buffers
9. 10BaseT/ 10BaseTe / 100BaseTX Ethernet PHY integrated
10. Supports auto-negotiation (full/half duplex, 10 and 100-based)
11. Supports auto-MDIX only on auto-negotiation mode
12. Does not support IP fragmentation & jumbo packet
13. 3V operation with 5V I/O signal tolerance
14. Network indicator LEDs (full/half duplex, link, 10/100 speed, active)
15. 48 Pin LQFP & QFN lead-free package (7x7mm, 0.5mm pitch)
16. PIN-2-PIN compatible with W5100S

Package Includes:

1 x WIZnet W6100-Q